Rivera Knucklehead Reverb KR 100 T Guia de Resolução de Problemas descarregar pdf (Página 30)

Knucklehead Reverb 1.0 p 30

Sending a direct signal to P.A. or recording gear

Z OUT

560 Ω

TOTAL

MIN. Z 4 Ω

IMPEDANCE

SELECTOR

SPEAKER 2

100W. RMS

SPEAKER JACKS

IN PARALLEL

SPEAKER 1

USE FIRST

TO SPEAKER

CABINET

RECORDING

OUTPUT

LINE INPUT

Using a shielded cord, connect the 's Recording Out to the line input or channel input of

a mixer or recorder. (The signal comes from the amp's Preamp section, so all tone,

distortion, and overdrive characteristics are included.) If you are not using the Effects

Loop, you can use the Effects Loop Send jack instead of the Recording Out.

Remember, the Recording Out is internally equalized for a good "direct" tone, but it has

no output level control.

The Effects Send is not equalized, and its level is adjustable.

Caution: Never use the speaker output to drive ANY Line Level Input.

You will need to adjust the equalization of the mixer carefully, as this sound differs

greatly from a sound heard by a microphone placed in front of a speaker cabinet. Using

a "Cabinet Emulator" in the signal path may be a good idea to try. Speakers act as

giant filters, and as the signal from the Recording Out is equalized internally, not

affected by the mechanical-acoustic filter of a speaker.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 43 44

Sem comentários

Rivera Knucklehead Reverb KR 100 T Guia de Resolução de Problemas Página 30